Skip to content
TapBuff

City of Rexburg

EPA’s and the City of Rexburg’s records have results for 37 contaminants in its water; 7 were found.

Serves 40,695 people · Groundwater · Rexburg, ID

Serves
40,695 people
Connections
4,525
Water source
Groundwater
Based in
Rexburg, ID
County
Madison
Owner
Local government
The 2 ZIP codes it serves

83440, 83460

The short answer

None of the results here is above a limit in force today. Lithium is above EPA’s health benchmark. 1 health-based violation since 2016, resolved in EPA’s file.

This is what the records show, not medical advice. Worried about a health effect? Talk to a doctor or your local health department.

Filters for arsenic, lead and uranium, if you want them lower⁠The violation⁠Got a notice? What it means⁠

What was found

Where these results come from, and when

PFAS and lithium: EPA UCMR 5, samples taken from April 24 to Oct. 9, 2023.

Lead and copper: EPA SDWIS monitoring periods ending 2007 to 2024.

Fluoride, arsenic and uranium: the annual water quality reports the City of Rexburg publishes, 2024 to 2025, with EPA’s 2012 to 2019 file for earlier years.

Nitrate, chromium (total) and total trihalomethanes (TTHM): EPA’s compliance monitoring file, samples taken from July 11, 2012 to Dec. 17, 2019. Newer results are in the utility’s annual water quality report.

What the lines mean
Legal limit (MCL):
Enforceable. The most a utility may deliver.
Action level:
Triggers action. If more than 10% of homes sampled are above it, the utility must act.
90th percentile:
How a lead or copper result is held against its action level: nine in ten of the homes sampled were at or below it.
Health goal (MCLG):
Not enforceable. The level with no expected risk, with a margin of safety.
Health reference level:
A screening level from EPA’s work on whether to regulate a contaminant, where there is no legal limit or health goal; not enforceable.

PFAS: None of the six PFAS in EPA’s 2024 drinking water rule was found in this utility’s samples. None of the other 23 PFAS tested for was found either.

Above EPA’s health benchmark, 1 result

Lithium

Comes from the source

Above EPA’s health benchmark

29.6 ppb

Highest sample, April 24, 2023; found in 6 of 8

The highest sample was 29.6 ppb, about 3 times EPA’s health reference level of 10 ppb. That is a screening level, not an enforceable limit.

What handles it

No filter certification covers lithium yet, and EPA’s 2023 fact sheet says boiling doesn’t remove it. Because it was found, your utility has to report its lithium results in its annual water quality report, where newer ones will appear.

How to read your utility’s report

Below EPA’s limits, 6 results

Arsenic, lead and uranium have a health goal of zero: the level with no known or expected risk. Any amount found is above it, but the goal isn’t a limit.

Legal limit (MCL):
Enforceable. The most a utility may deliver.
Action level:
Triggers action. If more than 10% of homes sampled are above it, the utility must act.
90th percentile:
How a lead or copper result is held against its action level: nine in ten of the homes sampled were at or below it.
Nitrate, Legal limit 10 ppm; highest 3.3 ppm

Highest sample; found in 58 of 58 · 2019 average: 2.5 ppm · Comes from the source

The highest sample, in 2019, was 3.3 ppm, below EPA’s legal limit of 10 ppm. That was also the latest year on file, and its seven samples averaged below the limit.

What handles it

  • NSF/ANSI 58 look for “Nitrate/Nitrite Reduction”
  • NSF/ANSI 53 look for “Nitrate/Nitrite (30 ppm challenge)”
About nitrate
Fluoride, Legal limit 4.0 ppm; highest 1.1 ppm

Highest result, 2024 · Forms or is added in treatment

The highest sample, in 2024, was 1.1 ppm, below EPA’s legal limit of 4.0 ppm.

Earlier, 2012 to 2019

From 2012 to 2019, EPA’s file shows a highest yearly average of 1.4 ppm, in 2012.

What handles it

About fluoride
Arsenic, Legal limit 10 ppb · health goal zero; highest 2.0 ppb

Highest result, 2025 · Comes from the source

The highest sample, in 2025, was 2.0 ppb, below EPA’s legal limit of 10 ppb. Its health goal is zero, so any amount found is above it; the goal isn’t a limit.

Earlier, 2012 to 2019

From 2012 to 2019, EPA’s file shows a highest yearly average of 2.4 ppb, in 2012.

What handles it

  • NSF/ANSI 58 look for “Arsenic (Pentavalent)<=50 ppb Reduction”
  • NSF/ANSI 53 look for “Arsenic (Pentavalent)<=50 ppb Reduction”
About arsenic
Lead, Action level 15 ppb · health goal zero; 90th percentile 2.0 ppb

90th percentile, 2022 to 2024 · Comes from pipes, often your own

In the latest period, 9 in 10 homes sampled were at or below 2.0 ppb, below EPA’s action level of 15 ppb. The action level drops to 10 ppb on Nov. 1, 2027. EPA’s health goal for lead is zero.

What handles it

About lead
Uranium, Legal limit 30 ppb · health goal zero; highest 3.0 ppb

Highest result, 2024 · Comes from the source

The highest sample, in 2024, was 3.0 ppb, below EPA’s legal limit of 30 ppb. Its health goal is zero, so any amount found is above it; the goal isn’t a limit.

Earlier, 2012 to 2019

From 2012 to 2019, EPA’s file shows a highest yearly average of 2.6 ppb, in 2018.

What handles it

About uranium
Chromium (total), Legal limit 100 ppb; highest yearly average 2.1 ppb

Highest yearly average, 2012 to 2018 · 2018: not found · Comes from the source

Averaged by year, the highest was 2.1 ppb, in 2012, below EPA’s legal limit of 100 ppb. In 2018, the latest year on file, it wasn’t found in any of its two samples.

What handles it

About chromium (total)
Utilities above EPA’s PFAS limits, state by state⁠
30 compounds tested and not foundIncluding all six PFAS in EPA’s 2024 rule. Below the reporting level in every sample. Not found is not the same as zero.

From routine monitoring

  • Total trihalomethanes (TTHM)

PFAS and lithium, from EPA’s UCMR 5 sampling

  • 11Cl-PF3OUdS
  • 4:2 FTS
  • 6:2 FTS
  • 8:2 FTS
  • 9Cl-PF3ONS
  • ADONA
  • HFPO-DA (GenX)
  • NEtFOSAA
  • NFDHA
  • NMeFOSAA
  • PFBA
  • PFBS
  • PFDA
  • PFDoA
  • PFEESA
  • PFHpA
  • PFHpS
  • PFHxA
  • PFHxS
  • PFMBA
  • PFMPA
  • PFNA
  • PFOA
  • PFOS
  • PFPeA
  • PFPeS
  • PFTA
  • PFTrDA
  • PFUnA

Violations since 2016

1 health-based violation since 2016 for the Revised Total Coliform Rule. It began Sept. 1, 2017.

Resolved:
EPA’s file records a resolving action. The utility came back into compliance, the rule no longer applied, or no further action was needed.
No fix on record:
It records none. EPA’s own word for these is archived, addressed or unaddressed, shown beside each (EPA’s definitions, updated Oct. 9, 2026).

EPA’s file runs to 2026 Q3, so a notice your utility sent since then may not be here yet.

Got a notice about one? What it means and what to do⁠
Health-based violations, newest first
Contaminant or ruleWhat happenedPeriod, and what was measuredStatus
Revised Total Coliform RuleE. coli was confirmed in the water system.EPA: Maximum Contaminant Level Violation, E. coli (RTCR)Sept. 1, 2017 to Sept. 30, 2017Resolved

Health-based violations only. 70 monitoring or reporting violations not shown.

Skip past the filters

What handles it

A certification covers specific claims, not a whole standard. Look for these claims on the certifier’s listing, not the box.

  • NSF/ANSI 53

    Claims: Arsenic (Pentavalent)<=50 ppb Reduction, Lead Reduction

    For: Arsenic, Lead

    Other claims that cover it: Arsenic (III) (50 ppb influent level)

  • NSF/ANSI 58

    Claims: Arsenic (Pentavalent)<=50 ppb Reduction, Lead Reduction, Uranium

    For: Arsenic, Lead, Uranium

    Other claims that cover it: Arsenic (Pentavalent)<=300 ppb Reduction; Arsenic (V) (300 ppb influent level)

At the tap, or for the whole house?

These come with the water itself, so a whole-house system certified for the same claims treats every tap and shower. A filter at the tap treats drinking water for much less. How whole-house systems compare.

Filters with those claims on a certifier’s listing

Disclosure: TapBuff earns a commission if you buy through some links on this page. It does not change which standard or filter we name. As an Amazon Associate, TapBuff earns from qualifying purchases. How TapBuff makes money

2 more filters
Compare five-year costs

Every filter for these, those that cover all 3 first⁠

The best reverse osmosis systems, ranked⁠

The best water filters for lead, ranked⁠

Disinfectant

City of Rexburg reported adding no disinfectant at all 4 of its sampling points, in its 2023 sampling for EPA.

What that means

Most utilities add chlorine or chloramine. CDC says some that draw groundwater don’t need a disinfectant, because testing shows the water doesn’t carry enough germs to make people sick. This is what the utility reported for that sampling. Its annual water quality report says what it uses now.

What this report can’t tell you

  • Everything else. Fluoride, arsenic and uranium results here are from the annual water quality reports the City of Rexburg publishes, from 2024 on, with EPA’s national file for 2012 to 2019. Nitrate, chromium (total) and total trihalomethanes (TTHM) come from EPA’s file alone, which ends in 2019: the reports read here give no figure for them across the whole system. City of Rexburg’s own annual report, which it must send you every year, has the contaminants this page does not show.

  • Your own plumbing. Lead results are the 90th percentile across homes the utility samples. Your home’s service line, solder and fixtures decide yours. A certified lab test is the only way to know.

  • What it means for your health. This page reports what the records show and EPA’s limits and goals; it is not medical advice. If you are worried about a health effect, talk to a doctor or your local health department.

  • Anything after the latest data. SDWIS data is from 2026 Q3; UCMR 5 samples are from April 24 to Oct. 9, 2023; the reports the City of Rexburg publishes cover 2024 to 2025; EPA’s compliance samples are from July 11, 2012 to Dec. 17, 2019.

Testing your own tap

City of Rexburg’s results are for the water it sends out. What your own service line, solder and fixtures add shows up only in a test of your tap, by a lab Idaho certifies.

What to test for at your tap

  • Lead and copper. Both come mostly from a building’s own service line, solder and faucets, so a utility’s numbers can’t tell you yours. City of Rexburg’s latest lead sampling in EPA’s records, 2022 to 2024, had a 90th percentile of 2.0 ppb: 9 in 10 of the homes it sampled were at or below that. The action level is 15 ppb, dropping to 10 ppb in November 2027, and EPA’s health goal for lead is zero. About lead.
  • What City of Rexburg’s results flag: lithium. It is in the water the utility sends out, so a test of your tap mostly confirms it. Include it if you want a number for your own home.
The 3 labs Idaho certifies closest to the area City of Rexburg serves, or a kit by mail

The 3 labs Idaho certifies closest to the area City of Rexburg serves, in a straight line. Call first: certification is test by test, and not every lab takes samples from homeowners.

  • Teton Microbiology Laboratory

    Idaho Falls, ID · about 25 miles

    Certified for bacteria

  • Teton County Water Laboratory

    Jackson, WY · about 66 miles

    Certified for bacteria

  • IAS EnviroChem Laboratory

    Pocatello, ID · about 73 miles

    Certified for bacteria, minerals and other inorganics

All 33 certified labs for Idaho⁠

Or test by mail

Tap Score sells lab tests as kits you fill at your tap and mail back. The sample goes to Tap Score’s lab, not one near you, so check that Idaho certifies it for the test you want.

  • Tap Score

    Return shipping included.

    Tap Score says each kit ships to “an accredited laboratory” but doesn’t name it, so TapBuff can’t check it against Idaho’s list.

Prices from Tap Score’s own store on Oct. 22, 2026.

What to do now

Sources

PWSID ID7330022. Rebuilt from EPA data on Oct. 25, 2026.